Touch-sensor systems can be printed in the form of singles buttons, sliders or matrices, using direct printing onto flexible substrates, such as membranes, glass plates or alternative surfaces, such as enclosures, for example. a touch-sensor membrane can, for instance, be bonded behind non-conductive surfaces in order to convert these surfaces into a membrane keypad.Direct printing of enclosure parts with touch sensor systems makes it possible to efficiently combine production operations, save resources and reduce consumption of materials. This cuts materials costs and lowers the risk concerning the long term stability of adhesively bonded joints. To assure reliable signal evaluation, our sensor electronics are supplied with a customised flat connector for immediate connection to the existing system.The necessary signal evaluation can also be optionally implemented directly on the membrane. Correct functioning is then assured even in the presence of droplets of water or fouling on the surface.

• Cost-savings thanks to combination with graphical printing
• Plug & Play sensor-surface and controller solution
• Reduced risk of failure
• Direct printing of alternative surfaces
• Good optical transparency
• No mechanical wear
• Easy cleaning thanks to sealed surfaces

antennas of various geometries are needed for rFID products, depending on the particular application. The geometry of the antenna is optimised for its electrical data and is not restricted to rFID. We design the antenna geometry needed for your application and can print it using our tried-and-proven copper technology.

Copper technology provides greater range, faster read potentials and higher data-transmission rates com- pared to conductive silver.

In addition, we use NFC and rFID chips to integrate a passive digital identifi- cation feature into the membrane for you.

NFC technology can also act as an interface with the machine, making it possible to transmit condition scans or measured data, for instance. It is not necessary to pierce the enclosure for this purpose, with the result that a high IP ingress protection rating can be achieved.

a large range of digital products for the most diverse applications, such as anti-tamper seals, moisture sensors, process-monitoring cards and input systems using an NFC interface, for example, can thus be implemented.

• Range up to 7 cm thanks to copper technology
• Direct integration into front membranes and membrane keypads
• Password-protected memory contents
• Many diverse potential applications
• Easy and cost-efficient integration into existing systems, even in small production runs

Pressure sensor systems：

• Low-profile and lightweight
• Combinations with other sensors also possible
• Sensor electronics can be inte- grated to achieve better scal- ability
• Customers’ designs can be inte- grated straight into the sensor

Printed heaters：

• Low-profile, lightweight and flexible
• Can be integrated into membrane keypads, glass and touch systems
• Self-regulating or with integrated measuring electronics
• Up to 200°C in continuous operation (depending on overall system)